thickness n. 1.厚;粗;厚度;粗大。 2.濃度,濃厚,黏稠。 3.密度;稠密。 4.模糊不清,多煙霧,混濁。 5.愚笨;遲鈍。 6.最厚[粗,密,濃]處。 7.(有一定厚度的東西的)一張,一層。 8.親密。 coal seams of less thickness than five feet 厚度不及五英尺的煤層。 the thickness of population in New York 紐約的人口密度。 wood of different thickness 厚度不同的木頭。 five thicknesses of cardboard 五層紙板。
sampling n. 1.取樣(品),取標(本)〔指行動或程序〕。 2.樣品,標本。 3. 剽竊拼湊歌曲。
Moreover, the turning point that is n't yet reported by relative literature before is found in the earlier stage of crystallization when the sample thickness reduce to the desired value 隨著研究的深入,發現當樣品厚度降到一定值時,在結晶過程開始后不久就會出現一個初期轉折點。
Found relationship on increasing value of saturation darkening degree ds and activation intension . discussed nonlinear relationship of photochromic glass between saturation darkening degree ds and sample thickness 討論了光致變色玻璃飽和變暗度(d_s)值與試樣厚度(1)之間的非線性關系。
The debinding defects could be caused by inappropriate debinding parameters such as temperature in creasing schedule, constant temperature time . the logarithm of weight loss was proportional to the reciprocal of sample thickness at temperature below 280c 粘結劑的脫脂行為決定脫脂工藝,脫脂缺陷與升溫速率、保溫時間、氣氛流量和壓力、以及產品厚度有關,溫度小于280時,脫脂量的對屬與厚度的倒數成比例。
The sample thickness declining, provided the number of nuclei per unit volume fix, the value of the avrami exponent n falls, but the values of vc and s almost do n't change . when the value of thickness reduce to the average diameter of entities, the turning point turn up after the course of crystallization has begun soon 當單位體積內晶核數目不變時,樣品厚度h減小,n減??;v_c和_s值基本不變:當h降到小于等于體系內球晶的平均直徑時,在結晶最初期,會出現一個初期轉折點。
In this paper, the course of isothermal crystallization kinetics of polymer in limited volume unit is simulated by use of the method of monte carlo . four factors influenting on the course of polymer in the limited volume unite isothermal crystallization are analyzed under the given conditions . the four factors are sample volume shrinkage, the change of the linear growth rate of entities g, the change of sample thickness and the change of the number of nuclei 本文采用montecarlo方法研究了高聚物在有限體積元中的等溫結晶動力學過程,分析了在一定條件下,樣品體積收縮、晶體線生長速率變化、樣品厚度變化和晶核數目變化這四種因素對高聚物在有限體積元中的等溫結晶過程的影響。